Do Old Above Ground Tanks Need To Be Registered In Il

Clarification of the Terms "Bulk Storage" vs "Dispensing" Tanks

Bulk Storage Tanks

The term "bulk" is often incorrectly interpreted to mean a "large capacity" storage tank typically institute at majority plants or terminals. However, with the rules and operating procedures of the OSFM, the term "bulk" is not connected to the capacity of the tank, simply rather to simply distinguish the purpose of the tank storage from a "dispensing tank". Bulk storage tanks include tanks used for the storage of flammable or flammable liquids that are non dispensed straight into the fuel tanks of vehicles. Typical contents of bulk storage tanks include: fresh and waste motor oils, transmission and hydraulic fluids, petroleum products stored for off-loading into bulk storage trucks, chemical products (if combustible or flammable) and emergency generator fuel tanks. (Note: even though products such as fresh motor oils or manual fluid are intended for use in vehicles, they are not dispensed into the fuel tanks of the vehicles and therefore the OSFM classifies such tanks equally bulk storage tanks and not every bit "dispensing" tanks. Likewise, if combustible or combustible products are off-loaded from an aboveground tank into the cargo tank of a bulk storage truck, such a tank would be considered a bulk storage tank and not a dispensing tank. The tank would only be designated as a dispensing tank if the contents of the tank are dispensed directly into the fuel tank of vehicle - in other words, the vehicle'due south motor runs off the product being dispensed into the fuel tank).

An application to, and subsequent field inspection by, the OSFM is required for the installation or relocation of bulk ASTs greater than 110 gallons capacity.

Dispensing Tanks

The term "dispensing" is used by the OSFM to distinguish a tank from a majority storage tank. "Dispensing", means the activity of transferring a flammable or flammable liquid from an aboveground storage tank to a vehicle, mobile equipment, engine or motor for use every bit fuel past them; "dispensing" also includes such transference into a receptacle, such as a gas can.

Dispensing storage tanks contain products that are dispensed directly into the fuel tank of a vehicle. Typical contents of dispensing storage tanks include: gasoline, diesel fuel, biodiesel, gasohol, and gasoline/ethanol blends. The rules prohibit the retail sale/dispensing of fuel by the public from dispensing AST. Role 180 provides regulations for the permitted dispensing scenarios along with the maximum amount permitted to be stored. The most mutual dispensing activity is found in what OSFM calls "fleet services" or storage at commercial, industrial, governmental or manufacturing establishments for fueling vehicles used in connection with their business. The maximum full amass volume permitted for this fleet action is 12,000 gallons.

Registration of Aboveground Storage Tanks

Unlike USTs, at that place is is no requirement for the registration of ASTs. The OSFM does not maintain a database of ASTs installed in Illinois.

Airport Dispensing Sites

Retail auction of aircraft fuel from an aboveground tank is allowed to be conducted at an airdrome facility. Dispensing is simply for aircraft and not into over-the-road vehicles. These installations are permitted to have two tanks with capacities upward to 10,000 gallons per tank. Airport Dispensing installations must comply with more stringent installation rules. These installations at airports must exist approved by both the Illinois Department of Transportation's Division of Aeronautics as well equally the Part of the State Burn Marshal.

Applications Page

The proper awarding to be completed and submitted to the OSFM for airport sites is the "Aboveground Airport Dispensing Storage Tank Application".

Mining and Coal-Fired Electric Generating Facilities

Mining and coal-fired electric generating facilities are allowed to have two tanks up to 12,000 gallons each. Additionally there are specific installation restrictions for these larger tanks. The installation restrictions include increased separation distances to buildings and property lines, limiting storage to off-road diesel fuel fuel, and an understanding to the installation by the local burn down section. The proper awarding to be completed and submitted to the OSFM is the "Application for Above Footing Storage Tank Installation for Motor Vehicle Fuel \ Dispensing Purposes". Information technology should be noted that additional ASTs for on-road vehicles are also permitted to be installed. See the information "Dispensing Tanks."

Information Applicable to Both Bulk and Dispensing ASTs

In that location is no fee required for the OSFM'southward review or field inspection of aboveground storage tanks. All applications for aboveground liquid (bulk or dispensing) storage tank installation or relocation must be completed, and submitted to OSFM Technical Services Division.

All storage tank applications must be accompanied by one copy of site plans showing the required data.

AST installation and relocation work is not required to be conducted by a licensed contractor.

Applicants volition return correspondence from the OSFM subsequently a review of the applications and plans has occurred. If all necessary information is included in the submittal, average turnaround time for submitted AST applications is x business concern days.

The render correspondence includes instructions that the tanks may not be filled with product until an on-site inspection is conducted past an assigned inspector of the OSFM. The OSFM application review letters also copied to the local fire authority. The correspondence also includes a phone number and an email where installers or owners can contact the OSFM to asking the assignment of an inspector to conduct the on-site inspection. The OSFM awarding review letters will continue to exist copied to the local burn down authority.

Bulk ASTs used to Fuel Fire Pumps

Policy Statement - Internal Emergency Valves for AST'southward Supplying Fire Pumps

Contact Information

Requests for bare applications or copies of applicable rules, as well as full general dominion interpretations of the Part 160 and 180 rules are handled by the OSFM's Technical Services Division. This partition too reviews the AST installation applications. Field inspections of aboveground tanks are conducted past OSFMs Fire Prevention Sectionalization. If you have questions related to scheduling an inspection or determining the results of a completed inspection, you should contact the Segmentation of Fire Prevention'due south offices in Springfield at (217) 785-4714 or in Chicago at (312) 814-2693. If yous have questions related to the status of a submitted application or the contents of an application review letter, you should contact the Division of Technical Services by email.